Here's a list of the current aftermarket atv mods on this DVX:
- AC racing bumper (powder coated black)
- (front) ITP Baja wheels, ITP Quad cross tires
- Lonestar Hubs (powder coated Green)
- Upgraded from Alba +2 aarms that I had powder coated white from black, to White Roll Design +2 long travel AArms
- Alba brake line clamps (powder coated green)
- Streamline +2 stainless steel braided brake lines
- Upgraded from Alba +2 Tie rods (powder coated green) to Roll Design Tie Rods
- Steering Knuckles powder coated green
- Headlight removed, tail light removed, light controles removed from
- the bars, reverse removed, key removed, temp/rev/N light cluster removed and rewired for push button start
- Black headlight cover held in with safety wire
- upgraded from Elka triple rate shocks to Motowoz long travel
- Houser steering stem (Black) with Anti Vibe bar clamps (powder coated white)
- Upgraded from Renthal bars to MSR Bars
- Moose Racing Clutch Perch
- ODI Lock on grips
- Green Vent tube for gas cap
- Oil Tank Powder coated white
- Upgraded from Arctic Cat nerfs to UM black nerfs
- Motor mounts powder coated white
- Athena Big Bore kit
- Stage 2 hot cams
- Edelbrock Carb
- UNI filter
- Yoshimura RS-2 Comp series Exhaust upgraded from Alba full Exhaust
- Green CV4 Hoses
- Black Verde gripper seat cover
- (Plastics) New Black center section cut in half for easy removal, New Green fenders
- Custom Graphics from Blown Concepts
- Frame and Sub Frame Powder Coated Green
- AC Racing Skid Plate
- Alba Case saver and Block Off Plate
- Alba Swing Arm powdercoated white from black
- Up graded from a Elka Dual rate rear with remote res to a Motowoz Long travel with remote res.
- Elka Linkage
- Green rear Streamline stainless steel braided brake line
- DID 520 ATV Chain
- T.M. Designworks chain guide
- Titax front and rear sprocket (powdrecoated white)
- Titax Rotors
- DuraBlue Eliminator +2 Triple chromed Axle
- LoneStar Racing hubs (powder coated green) and Locking nuts on Axle
- AC Racing Grab Bar W/numberplate (powder coated black)
- Douglas Yellow Label beadlock rear wheels with ITP Quad cross Tires
- Yoshimura Mud Plugs in the wheels
- Hinson Clutch Basket
- Barnett Dirt Digger Clutch Kit
- I run amsoil oil, Purple Engine Ice coolant, and Torco 110 Race fuel (great stuff but spendy at $9 a gallon)
Special thanks to Cory for the pics and info!
and Cory wants to thank Quad Central Motorsports in Ham Lake, MN for all their help!
|
DVX 400 Left Side
DVX 400 Right Side
Artic Cat DVX Rear View
Arctic Cat DVX Front View
|
